To return to the operation menu and continue
your inspection, press
1.5 Mounting the protection ring
Before every inspection, check the probe if the
protection ring is mounted. Carefully mount and
remove the parts. Never use force for this proce-
dure. In case of doubt, contact our service to get
further instruction.
To mount the protection ring to the probe head
(double thread protection), follow further instructions:
1. Screw the protection ring on the probe heads
first thread.
2. Then, push the protection ring gently to the second
thread. Screw the protection ring to the probe
heads second thread to mount it. For removing the
protection ring, please proceed in reverse order.
1 STRUCTURE AND START-UP
11
NOTE! Do not remove the SD card during cap-
turing photos or video. This can cause a loss
of the image or video and may damage the SD
card!
NOTE! Do not store the device in low
temperature environment! If stored in
low temperature environment, warm up
the device before starting or operate
with usual power supply.
NOTE! The video icon is blinking red while
recording.
NOTE! Video recording requires an SD card
with fast writing speed. We recommend 80x
(or above) writing speed SD cards for better
video quality!
NOTE! Wait 5 seconds after recording, before
removing the SD card!
ATTENTION! Never use the probe without the
protection ring! Operation without the
protection ring may damage the probe!
ATTENTION! The change of the tip adapters
must be performed by briefed personnel only!
ATTENTION! Due to small dimensions, the
threads of the probe and the protection ring
/ tip adapters are very delicate. To prevent
any damage, pay attention to dirt in the threads!
1.5b
1.5c
1.5d
1.5e
NOTE! Always release the SD card performing
the „Release card“ menu! Releasing the SD
card without performing via specific menu
might damage the SD card and/or the data!
1.5a
