VIVOTEK
User's Manual - 81
■ Transparent HTTP Tunnel: If you want to use your own RS-485 device, you can use UART commands
to build a Transparent HTTP Tunnel. The UART commands will be sent through HTTP tunnel
established between the RS-485 device and the linked camera. For detailed application notes, please
refer to URL Commands on page 112 or http://www.vivotek.com/downloadfiles/faq/videoserver/UART_
HTTP_Tunnel.pdf.
Preset positions
If you select DynaDome/SmartDOME, Lilin PIH-7x00, or Pelco D, Pelco P protocol, Samsung scc643
protocol protocol as the PTZ driver and click the
Save
button, the
Preset Position
button will be enabled.
Click
Preset Position
to open the settings page. You can also select preset positions for the camera to
patrol. A total of 20 preset positions can be configured.
Please follow the steps below to preset a position:
1. Adjust the shooting area to the desired position using the buttons on the right side of the window.
The
default
Home
position is set as the center position.
2. Enter a name for the preset position, which allows up to forty characters. Click
Add
to enable the
settings. The preset positions will be displayed under
User preset locations
.
3. To add additional preset positions, please repeat steps 1~2.
4. Select the preset positions and click on
Save
to enable the settings.
5. The positions saved will show up in
Go to
drop down list on the Home page.
6. To remove a preset position from the list, select it and click
Remove
.
2011/03/10 17:08:56
2011/03/13 17:08:56
Functions are the same
as the Control Panel on
the home page
1
4
6
2
5
Summary of Contents for IP8362
Page 1: ...Rev 1 1 ...
