VIVOTEK
10 - User's Manual
1� Disassemble the components of the
waterproof connector into parts (A) ~ (F) as
shown above�
2� Place the screw nut (E) on the Power and
GPIO opening�
3� Feed the power cables through the
waterproof connector (F --> E --> D --> B -->
A) as the illustration shows� Then connect
the power cables to the power source� Note:
There are 8 holes on the seal (D), and the
widest holes with a crack on the side are
specific for power cables.
4� If you have external devices such as
sensors and alarms, feed the cables
Assembling Steps
Sealing Nut (A)
Housing (B)
Seals (C)
Seal (D)
Screw Nut (E)
Hex Nut (F)
Waterproof Connector
(A)
(B)
(D)
(E)
(F)
through the waterproof connector (F --> E -->
D --> B --> A) as previously described� Refer
to the pin definition to connect them to the
general I/O terminal block� Note: The recom-
mended cable gauge is 2�0 ~ 2�8 mm�
5� Push the seal (D) into the housing (B)�
6� Insert the seals (C) into unused holes on the
seal (D) to avoid moisture�
7� Secure the sealing nut (A) tightly and hex nut
(F) from the bottom of the camera�
1
2
RJ45 Cable Dimension (unit: mm)
2� Strip part of the sheath from the Eth-
ernet cable�
1� Drill a hole on the rubber seal plug
and insert an Ethernet cable through
the opening�
Rubber Seal
Plug
Assembling Steps:
Recommended cable gauge: 24AWG (0�51 mm)
Connecting RJ45 Ethernet Cable
