VIVOTEK
68 - User's Manual
■ Synchronize with digital input
The Network Camera automatically removes the IR cut filter when a digital input is triggered, for
example, when the camera is accompanied by an external IR light that comes with its own sensor and
provides a signal to the camera. Some camera housings come with such mechanism.
■ Schedule mode
The Network Camera switches between day mode and night mode based on a specified schedule.
Enter the start and end time for day mode. Note that the time format is [hh:mm] and is expressed in
24-hour clock time. By default, the start and end time of a day mode are set to 07:00 and 18:00.
Sensitivity
Tune the responsiveness of the IR filter to lighting conditions as Low, Normal, or High.
When completed with the settings on this page, click
Save
to enable the settings.
If you want to configure another sensor setting for a specific lighting condition in day/night/schedule
mode, please click
Profile
to open the Profile settings page as shown below.
Please follow the steps below to setup a profile:
1. Check
Enable and apply this profile
.
2. Select the applied mode:
Day mode
,
Night mode
, or
Schedule mode
. Please manually enter a range
of time through which you want the Schedule mode to apply.
3. Configure Exposure control settings in the folowing columns. Please refer to page 69 for detailed
information.
4. Click
Save
to enable the setting and click
Close
to exit the window.
