Vivo Select 8000 Cordless User Guide
Page 8 of 10
Message Reminder
When the light on the handset and base unit blinks red, it means you have a message.
Message Retrieval
When the light on the base is blinks
red, pressing the light key or press key “1” of the handset for 3 seconds, to
retrieve the message.
When two lines both have messages, Line1 will default as the priority, repeat step 1 to retrieve the line2 message
accordingly.
If you want to listen to the message again, press “1” for 3 seconds to pick up the Line 1 message; press “2” for 3
seconds to pick up the Line 2 message; (available for two lines only)
Adjusting the Ringer Volume and Assigning the Ringing Tones
To assign a ring tone pressing the FLASH key for 3 seconds, then dial number key, (from 1~6) to select the
desired ring tone. Adjust the ring volume control by pressing either the Vol+ or Vol- key after that press FLASH
key to confirm. (On-hook state)
Adj
ust the Base ringer volume: to select “ HI or LO “ switch on the bottom of the base to adjust the ringer
volume.
Storing a Number Into Memory Keys
On-off state using the handset to store a number into the memory keys as following instructions:
Memory key Settings:
at on-
hook mode, press “HOLD and * ” enter the number “5238”, the handset LED will blink
press the desired memory location code as figure 1 (1~12 optional)
press” # and *” and enter the number to be stored
press HOLD key to end the programming
For example: if you want to save 886 into “Service Center” , corresponding to location code 3, just pressing “ HOLD
5238 3
＃
886 HOLD” is available.
