DU8395Z Series DLP Projector - User Manual
UM83950922EN01
50
•
If using Ultra Short Throw Lens and setting to Non-UST Lens, the lens will be moved to the position which is
lower than the default position of Ultra Short Throw Lens after performing Center Lens function, it causes the
projected image is blocked by the top cover of the projector. In this case, please perform the Lens shift function
to move up the Lens till the image can be projected normally.
•
When using a zoom lens or a fixed-focus lens, if the lens shift range is limited and cannot be projected normally,
make sure that the lens type is correctly setting as a non-UST lens, then perform the lens position centering
function and then re-adjust the lens. Control and other functions to get the correct projection picture.
Lens Memory
This projector supports Lens Memory function, Lens shift, Zoom and Focus memory can be stored in the projector up
to 10 sets. You can load the stored memory setting to set up the lens automatically.
Select Lens memory 1~10 :
ENTER key to Save/Load. Press ► to switch Load/Reset state. CLEAR key to Reset.
Center Lens
This is the lens calibration function, the projector calibrates the lens shift, focus and zoom parameters for the precise
lens memory function. After performing this function, the lens will be moved to the center position as factory default
setting.
Note
There are two default center positions for UST (Ultra Short Throw) Lens and non-UST Lens, make sure Lens Type
setting is correct before performing this function.
If an UST lens is installed, remove the support kit of the UST lens before performing Center Lens. After all the set
-
tings of the lens control are completed, then replace the support kit to fix the UST lens.
Digital Zoom
Press ENTER button to select the options to enlarge the image or shift the image.
Digital Zoom
Press ◄► to enlarge the projected image or retract the enlarged projected image back to the
original projected image size.
Digital Pan
Use ◄► to move the projected image horizontally. This function is only available when projected
image is enlarged.
Digital Scan
Use ◄► to move the projected image vertically. This function is only available when projected
image is enlarged.
Reset
The setting will be reset to default value.
Summary of Contents for DU8395Z
Page 1: ...DU8395Z User s Manual ...
