Vivitek DU8395Z, User Manual

Page: 23 / 69

DU8395Z Series DLP Projector - User Manual
UM83950922EN01
23
Adjusting Projected Image Position
This projector has the powered lens shift feature; the image can be shifted vertically or horizontally without moving the
projector. The lens shift range is shown in the percentage of the screen height and width, the maximum vertical shift
range can be up to 64% of the projected image height and down to 33% of the height, and maximum horizontal shift
range is 24% of the image width to right, 14% of the image width to the left. Please refer to below illustration.
The bounday of Lens shift
V: Projected Im-
age Height
H: Projected Image Width
64%
33%
14% 24%
Note
• The projector is equipped with safety switch inside the lens mount hole; the
projection lens must be installed in the projector before turning on the power.
PO
WE
R
STAT
US
LIGH
T TEMP
.
• If the projector detects no lens after the projector is turned on, the projector
will enter to protection mode (POWER-lights red, STATUS-red light flashes).
If this happens, turn off the projector's AC power and turn on the projector after
installing the lens.
• There is a Lens Lock function on OSD menu to disable lens control adjustment for avoiding possible
misoperation after you finish the adjustment, please make sure to disable the lock before performing the lens
control.
Adjusting the Focus and Zoom
The focus and zoom can be adjusted from the projector control panel or remote control. Refer to the following guides
to adjust the focus and zoom manually.
Press the Focus or Zoom button on the control key panel or remote control to adjust the focus or zoom effect using
the increase and decrease buttons as required
+ +
- -