DU8395Z Series DLP Projector - User Manual
UM83950922EN01
32
Using Control ID for Multi-projector Application
When installing more than one projector in the room, the projectors may receive the remote control signal at the same
time. In this case, you can use control ID function to specify the identification of the projector and remote control to
operate the specified projector. Follow below steps to set up the identification number for the projector and remote
control.
Step1: Set the Projector identification number
Before setting the ID control code of the infrared remote control, you need to specify its ID control code for each
individual projector. You can use the control panel on the projector to set the projector's ID control code, or use RS232
network control to set its ID control code.
5.
Enable Projector ID Control function from "CONTROL->Infrared Remote->ID Control Enable" as following figure.
Scroll
MENU = Back
Item Adjust
Language
Projection Mode
High Altitude
Auto Power Off
Auto Power On
Network
Light Power
Background
Startup Logo
Infrared Remote
Trigger
OSD Settings
Image Latency
English
Front Desktop
Auto
< off >
< off >
Black
< off >
< off >
ALIGNMENT
CONTROL
INPUT
SERVICE
PICTURE
The message box will display as following when enter the Infrard Remots. Selecting "ON" to active the ID Control
or "Off" to cancel use the ID setting.
Scroll
MENU = Back
Item Adjust
Infrared Remote
Remote Sensor
ID Control Enable
Control ID Number
On
Off
1
ALIGNMENT
CONTROL
INPUT
SERVICE
PICTURE
6. Set Control ID Number
Select Control ID Number option then press Enter buttons, use ► button to increase the number or ◄button to
decrease the number to set Projector ID. This option is available when "Control ID Number" is turned on. The
number range that can be set is 1-99
Control ID Number
26
Summary of Contents for DU8395Z
Page 1: ...DU8395Z User s Manual ...
