M
AINTENANCE AND
S
ECURITY
Replacing the Projection Lamp
The projection lamp should be replaced when it burns out. It should only be replaced with a certified
replacement part, which you can order from your local dealer.
Important:
1. The lamp contains a certain amount of mercury and should be disposed of according to local or-
dinance regulations.
2. Avoid touching the glass surface of the new lamp: Doing so may shorten its operation life.
Warning:
1. Be sure to turn off and unplug the projector at least an hour before replacing the lamp. Failure to
do so could result in a severe burn.
2. It is recommended that you do not attempt to replace the lamp while the projector is installed on
a ceiling. If you do attempt this, wear protective goggles to prevent glass from a ruptured lamp get-
ting into your eyes.
1.
Lift the screw cover (
A).
Remove the screw on
the lamp compartment
cover (
B
) and then lift
the lamp compartment
cover (
C
).
2.
Remove the two screws
from the lamp module
(
A
) and then lift the
module handle up (
B
).
3.
Pull up firmly to remove
the lamp module.
