Vivax WMH-2000L, User Manual

Page: 68 / 92

ENG
VIVAX
11
6) Press ” “
TIME/on
button, the display shows the previous setting turn-on
time by default. Press ” “
TIME/off
button continuously to set the turn-off
time. Such as set the shutdown time at 13:00pm (the display as figure E),
(Note: turn-off time later than turn-on time, when turn-on time same as turn-
off time, the unit in stand by mode)
7) Repeat steps
3 - 6
, you can set the whole weekly program (& Each day, the
work of each segment opens, the time of shutdown), press
” “
OK
button
to
confirm the setting.
8) After above setting, press “ “
DAY
button, choose the unit turn-on day of
the week, then press “ “
EDIT
button to choose the turn-on time of the
day, then Press ” / “ to set desired temperature (temperature range 10-
49°C), press
” “
OK
button
to confirm the setting.
If the setting temperature not set, the default temperature 23°C, if room
temperature higher 23°C, the unit not switch on.
To cancel the weekly function, press the “ “
PROGRAM
button again, the
light "
P
" will go off. The weekly program is off. The unit will revert to the
previous working mode.
Note:
- After the above setting are completed and P program is working, press” /
/ / “ to check the setting time of each day and time periods;
- The turn-on time periods 0~24 hours, cannot set to minutes;
- The“
TIME/OFF
”can not be less than“
TIME/ON
”;
- When the“
TIME/ON
” is the same as“
TIME/OFF
”, unit will enter into standby
mode
Note:
After power cut (Main switch was in off position or plug out), unit is reseted. Than you
need to set Time/Day settings. Press “ ” SET button to adjust Time /Day (see chapter
Set current TIME/DAY ).
Set open-window detection (ONLY by remote control)
Press “ “
Power
button ， the product enter into working mode. Heating will start.
Press” ”
Window
button by remote control, light “ / °C” light on; The temperature
display ”
23
” by default. Press
” / “
to set target temperature. During open-window
detection mode, once the room temperature drops 5-10
Ԩ
within 10 minutes, then the
product will stop working within 30 minutes and enter into stand by mode. To force Turn on
the unit , press “ “
Power
button again.
A B C D E