6 Loc-10Tx Transmitter
Page 37 of 72
6.2.4
Re-fitting the Battery Tray
Place top of catch over catch plate
Push up button underneath the catch – where
holding that up push in the bottom of the catch.
You will hear a positive “click” (Do NOT force
catches)
To close battery tray – slid transmitter (TX) onto tray, it will locate itself in the correct position, then close the
catches.
WARNING
Power “IN” socket
Two pins are used for power in from charger (to charge rechargeable batteries).
Two pins are used for power from external 12V DC source. A 12V DC power cable
is supplied and is designed to be connected to an automobile cigarette lighter
socket.
Contact Vivax-Metrotech or a Vivax-Metrotech approved service center for wiring diagram of plug, if
attempting to repair any of the “charging” leads.
6.2.5
Battery Charging and Disposal
Follow instructions detailed in the General Safety & Care portion of this document.
Only use the battery charger supplied. Using a non approved charger may damage the battery pack and
could cause overheating.
To charge, the batteries must be connected to the transmitter. Connect the mains charger to the charging
socket on the side of the transmitter and connect the charger to a suitable mains socket.
The LED will show a red light indicating that the charge cycle is in progress. When the batteries are fully
charged the LED will change to green.
NOTE
Rechargeable pack cannot be charged from a 12V DC source.
6.2.6
Battery Condition Indication
The battery condition (charge) is displayed on the left side of the display, in the case of the rechargeable
batteries the condition is also indicated on the charger (red/green light).
