Vivax Metrotech vLocDM, User Handbook Manual

Page: 25 / 54

Page 19 of 47
To select the frequencies you wish to use regularly – enter the
setup menu by pressing and holding the “i” pushbutton for 2
seconds. Use the “+” and “-” to select the word “Frequency”
– then press the “M” mode pushbutton to display the list of
available frequencies.
The receiver is capable of detecting a large number of frequencies. To simplify the operation of the equipment, it
is possible to activate only frequently used frequencies. This is done by entering the user menu.
The initial frequencies set at the time the unit is supplied are “Power”, “Radio” and the frequencies used by the
transmitter purchased. See the transmitter section for suggestions of which frequency is best suited to specific
applications.
The “+” and “-” pushbuttons are used to navigate the list of frequencies. To add a frequency to the "Frequently
used list", press the “Return” pushbutton and a dot will appear in the circle alongside the frequency. To deselect
a frequency, press the “Return” pushbutton and the dot will disappear. Once your selection is completed press “i”
pushbutton once to return to the setup menu, and again to exit the setup menu.
5.7 Setting Locate Mode
Press and hold the “i” pushbutton to enter the user menu. Use the “+” or “-” pushbutton to navigate to “Locate
Mode”. Press “return” pushbutton to select sub menu. The following will be displayed:
5 Receiver Functions and Operations
Peak Mode:
Largest signal over the pipe.