Vitek VT-EHL Series, Instruction Manual

Page: 34 / 96

VT-EHL Series
33
SYSTEM SETUP
SYSTEM SETUP
SYSTEM NAME : It is used so that notification emails can be identified.
F/W UPDATE : Firmware updates may be released periodically to enhance system performance and add extra features.
The operator must upgrade the firmware using a USB memory stick. The firmware is available for
download on the Vitek website http://vitekcctv.com/Downloads.asp . Once the firmware has been
downloaded, extract the firmware from the zip folder and put it onto a USB stick.
After inserting the USB stick (with firmware on it) into the DVR, Press UPDATE .
The following menu will appear:
After selecting the F/W from F/W list, press UPGRADE .
Then, F/W upgrade is started.
FACTORY DEFAULT : If settings have been changed , which cause erratic behavior, the factory default settings
can be loaded.
SYSTEM DATA : System settings can be saved to a USB memory stick. The settings can be reloaded
in case of accidental factory reset or can be transferred to another DVR if multiple
units need to be installed with the same settings. All information is saved apart from
network settings and system name.
PASSWORD : Determines the PASSWORD ON/OFF to enter specific menu.
SYSTEM : CONTROL DEVICE
This will allow up to 254 DVRs to be controlled by the same remote.
SYSTEM ID : If more than one DVR is connected on the same RS485 bus, each one must have a unique ID.
Note : If using more than one DVR on stack, each DVR must have a unique ID for control by remote controller.
PROTOCOL : Must be set by Control Device.
BAUD RATE : Must be set to match the baud rate of the controller.