Vitek VT-8435 Manual Instruction Download Page 5

Page: 5 / 28

ENGLISH

the lock (1) and turn it counter/clock-
wise to the position «

», release the

lock  (1)  and  make  sure  that  the  oper-
ating  surface  is  fixed  properly.  Install
the  second  operating  surface  in  the
similar way.

Note: - make sure that the operating sur-
faces (2) are selected correctly, the oper-
ating surface symbols on the locks (1)
should be similar when you press together
the halves of the unit.

–

Place the unit on a flat steady and heat-
resistant surface.

–

Insert the plug into the socket, switch
the unit on by setting the power switch
(5) to the «I»-position, the power indica-
tor (5) will light up.

Note: – when using the unit for the first
time, the heating element can produce a
foreign smell, this is normal.

–

Let the unit heat up.

–

Divide the smoothly combed hair into
locks of equal width (about 5 cm).

–

Place a hair lock between the sur-
faces (2) and press the surfaces (2)
together.

–

Holding the unit by the handle (3) and
the tip (1), move the operating surfaces
(2) to the tips of the locks without apply-
ing excessive force.

IMPORTANT:  under  no  circumstance  let
the  operating  surfaces  (2)  remain  in  the
same  area  of  the  hair  lock  for  more  than
2 seconds.

–

After that start straightening the next
hair lock.

–

Cool your hair down before finishing the
styling or applying hair spray.

–

Avoid contact of heated surfaces with
your face, neck and other parts of your
body.

–

After  use,  set  the  power  switch  (5)  to
the  position  «O»  and  take  the  power
plug  out  of  the  socket.  Let  the  unit
cool down.

–

Press the operating surfaces (2)
together and fix them by setting the
lock (6) to the horizontal position.

Note:

–

Always switch the unit off and unplug it
if it is not used.

–

Never leave the unit connected to the
mains unattended.

–

During the breaks in operation, place
the unit on a flat heat-resistant surface.

–

Do not comb the hair right after curling
it, let it cool down, divide big locks into
smaller ones carefully to make the hair-
style look natural.

Using other operating surfaces (2)

–

Set the operating surfaces (2) to the
position «

» to make 3D curls or

to the positions «

»,«

» to make

crinkles or deep waves on your hair.

–

To install the required operating sur-
face (2) press on the lock (1) and turn it
counter/clockwise to the required oper-
ating surface, release the lock (1)and
make sure that the operating surface is
fixed properly. Install the second operat-
ing surface in the similar way.

Note: - make sure that the operating sur-
faces (2) are selected correctly, the oper-
ating surface symbols on the locks (1)
should be similar when you press together
the halves of the unit.

–

Place a hair lock between the surfaces
(2) and press the surfaces (2) together.

–

Form a desired curl on the entire hair
lock.

–

Cool your hair locks down before finish-
ing the styling or applying hair spray.

–

After use set the power switch (5) to the
position «0» and take the power plug out
of the socket. Let the unit cool down.

–

Press the operating surfaces (2) togeth-
er and fix them by setting the lock (6) to
the horizontal position.

CLEANING AND MAINTENANCE

–