4
ENGLISH
•
To avoid damages, transport the unit in the
original package only.
•
Do not use the unit if the power cord or plug
is damaged, if the unit works improperly or
after it was dropped.
•
Do not attempt to repair the unit. Do not disas-
semble the unit by yourself, if any malfunction
is detected or after it was dropped, unplug the
unit and apply to any authorized service center
at the contact addresses given in the warranty
certificate and on the website www.vitek.ru.
•
Keep the unit in a dry cool place out of reach
of children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, ITS COMMERCIAL USAGE AND USAGE
IN PRODUCTION AREAS AND WORK SPACES
IS PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage at low
temperature keep it for at least three hours
at room temperature before switching on.
•
Unpack the unit and remove any advertis-
ing stickers that can prevent unit operation.
Unwind the power cord to its full length.
•
Check the unit for damages, do not use it in
case of damages.
•
Before plugging the unit in make sure that
the operating voltage of the unit corresponds
to the voltage of your mains.
Switching hair dryer on
Before switching the appliance on make sure
power supply voltage meets operating voltage
of the appliance.
• Insert power cord plug into wall outlet.
• Select operating speed you need using air-
flow speed switch (1):
0 = switched off;
I = low speed;
II = high speed.
• Select airflow temperature you need using
heating degree switch (2).
I = slight heating
II = medium heating
III = maximal heating
Taking care about your hair
Before drying and setting your hair, wash
them with shampoo, dry with towel to remove
excessive moisture and brush for better re-
sults.
Fast drying
Set switch (2) into position of maximal heating
(position III), select airflow speed you need us-
ing switch (1) and dry your hair out a little bit.
Shake off excessive moisture by hand or using
a brush and continuously move the hair dryer
over your hair.
Straightening your hair
Set switch (2) into position of maximal heat-
ing (position III), select airflow speed you need
using switch (1) and dry your hair out a little
bit. When your hair are almost dry, install con-
centrating nozzle (6), reduce degree of air
heating by switch (2) and airflow speed by
switch (1).
Divide your hair in locks and layers, and start
straightening them from lower layers upwards.
Bruch hair downright using round or flat brush,
simultaneously directing hot air blowing from
concentrating nozzle (6) on them. Straighten
each lock from root to tip this way. After you
have finished straitening locks of the lower lay-
er, start processing the locks of medium layer,
and so on, and finish with straitening locks of
the upper layer.
Natural waving structure of your hair
Set switch (2) into position of slight heating
(position I), then set switch (1) into position I,
hold a lock between your fingers tightly, turn
it to direction of its natural curliness, then dry
the lock out by directing air jet between the
fingers. After getting the shape you need,
press cool shot button (3) «
» and fix each
lock.
Rising up and volume
Using hair dryer in any mode of heating/any
speed from slight to maximal, dry out hair roots
beginning from backside of your head.
IM VT-8220.indd 4
18.07.2018 16:13:20
