5
ENGLISH
5
•
Close supervision is necessary when
children or disabled persons are near
the operating unit.
•
For children safety reasons do not leave
polyethylene bags used as a packaging
unattended.
Attention! Do not allow children to play
with polyethylene bags or packaging film.
Danger of suffocation!
•
Do not attempt to repair the unit. Do not
disassemble the unit by yourself, if any
malfunction is detected or after it was
dropped, unplug the unit and apply to
any authorized service center from the
contact address list given in the war-
ranty certificate and on the website
www.vitek.ru.
•
To avoid damages, transport the unit in
the original package only.
•
For environmental protection do not
discard the unit with usual household
waste after its service life expiration;
apply to a specialized center for further
recycling.
•
Keep the unit in a dry cool place out
of reach of children and disabled per-
sons.
THIS UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
BEFORE THE FIRST USE
After unit transportation or storage
at low temperature keep it for at least
three hours at room temperature
before switching on.
–
Unpack the unit completely and remove
any stickers that can prevent unit oper-
ation.
–
Check the unit for damages; do not use
it in case of damages.
–
Before connecting the power adapter,
make sure that voltage of the mains
corresponds to unit operating voltage.
–
Charge the battery and lubricate the
blade block following the recommen-
dations below.
The hair clipper can operate both con-
nected to the mains and on the built-in
battery.
Battery charging
Full charging of the accumulator battery
is enough approximately for
45
minutes
of continuous operation.
–
Switch the hair clipper off, setting the
power switch (
3
) to the “
O
” position.
–
Insert the power adapter (
12
) cord plug
into the connection socket (
1
) on the
lower side of the unit body.
–
Place the hair clipper on a flat stable
surface.
–
Plug the power adapter (
12
) plug into
the mains socket, the charging indica-
tor (
2
) will light up red.
–
When the charging is finished, the indi-
cator (2) will light up green.
–
The full charging time for the accumula-
tor battery is 8 hours; do not exceed it to
avoid reducing the battery operating life.
–
After the battery is charged, unplug
the power adapter (
9
) from the mains,
remove the adapter cord plug from the
connection socket (
1
), the charging
indicator (
2
) will go out.
Attention:
–
Strictly follow the sequence of oper-
ations when connecting the power
adapter. First connect the power
adapter jack to the unit power sup-
ply socket and then connect the
power adapter plug to the mains.
–
Charge the battery the first
2-3 times for 12 hours. The follow-
ing charging cycles time should not
exceed 8 hours.
–
To prolong the battery operating
life, it should be discharged com-
pletely before each charging cycle.
IM VT-2543.indd 5
15.09.2017 17:07:26
