ENGLISH
•
Install the filter holder into the coffee maker.
Holder ledges (19) should match the groves
on the boiler (pic. 5) and then turn the filter
holder handle (17) to the right till bumping
(pic. 6, 7).
•
Place a corresponding cup on a respective
tray (3 or 5) and turn the cappuccinator pipe
(2) to the cup using the bar (8) (pic. 8).
•
Insert the power plug into the mains socket.
•
Switch the coffee maker on by pressing the
button (14), the illumination o f the buttons
(23, 24 and 25) on the control panel will start
flashing.
N ote: If you d o n ’t use the unit fo r 15 minutes, it
will switch to the stand-by m ode autom atically
fo r safety reasons (bo ile r heating is switched
off, the illumination o f control buttons goes out).
Press any control button to switch back the o p
erating mode.
• When the control buttons stop flashing, press
the espresso button (23) once to make one
coffee cup (30-40 ml).
Note: Illumination o f the button (23) stops
flashing before the others - it is normal.
•
Press the button (23) twice to make two cups
o f espresso.
•
Press and hold the button (23) for 3 seconds
to make espresso at your discretion. The unit
can make up to 150 ml espresso and then will
be switched off.
• At your discretion you can switch the coffee
supply off by pressing the button (23) again.
Note: Repeated making o f coffee should be
perform ed a fte r at least 5 min interval.
Making cappuccino
Attention!
Be careful not to get burns by the
outgoing steam.
• Make sure that the unit is switched off.
• Remove the water tank (16), fill it with cold
water and install back to its place (pic. 1).
• Remove the milk tank (11), fill it with milk as
well and install back to its place (pic. 2).
• Add ground coffee into the filter: 2 full m ea
suring spoons - to make two coffee cups and
1 full spoon - to make one coffee cup, make
even and slightly tam p the ground coffee with
the back side of the measuring spoon (22).
• Install the filter holder into the coffee maker.
Holder ledges (19) should match the groves
6
on the boiler (pic. 5) and then turn the filter
holder handle (17) to the right till bumping
(pic. 6, 7).
•
Place a corresponding cup on the respective
tray (3 or 5) and turn the cappuccinator pipe
(2) to the cup using the bar (8) (pic. 8).
•
Insert the power plug into the mains socket.
•
Switch the coffee maker on by pressing the
button (14).
• The illumination of the buttons (23, 24 and
25) on the control panel will start flashing.
•
Select the “Cappuccino” mode by turning
the frothed milk supply knob (9).
Note: If you d o n ’t use the unit fo r 15 minutes, it
will switch to the stand-by mode autom atically
fo r safety reasons (bo ile r heating is switched
off, the illumination o f control buttons goes out).
Press any control button to switch back the o p
erating mode.
• When the control buttons stop flashing,
press the cappuccino button (24) once to
make one cup o f cappuccino.
•
Press the button (24) tw ice to make two cups
of cappuccino.
Making latte
Attention!
Be careful not to get burns by the
outgoing steam.
• Make sure that the unit is switched off.
• Remove the water tank (16), fill it with cold
water and install back to its place (pic. 1).
• Remove the milk tank (11), fill it with milk as
well and install back to its place (pic. 2).
• Add ground coffee into the filter: 2 full mea
suring spoons - to make two coffee cups
and 1 full spoon - to make one coffee cup,
make even and slightly tam p the ground
coffee with the back side of the measuring
spoon (22).
• Install the filter holder into the coffee maker.
Holder ledges (19) should match the groves
on the boiler (pic. 5) and then turn the filter
holder handle (17) to the right till bumping
(pic. 6, 7).
• Place a corresponding cup on the respective
tray (3 or 5) and turn the cappuccinator pipe
(2) to the cup using the bar (8) (pic. 8).
• Insert the power plug into the mains socket.
• Switch the coffee maker on by pressing the
button (14).
V T -1 5 1 4 _ IM .in d d 6
07.12.2012 9:29:24