ENGLISH
functions or if there are other damages in
the unit.
•
Do not repair the coffee maker by yourself;
always apply to the authorized service center.
THE UNIT IS INTENDED FOR HOUSEHOLD US
AGE ONLY
Before using the unit
•
Make sure that the unit is switched off.
• Attention! Before using the co ffee maker
fo r the first tim e remove the red rubber
plug from the w ater tank (16).
•
Before using the coffee maker for the first
time, wash all removable parts with warm
water and dry them.
•
Before switching the unit on, make sure that
the mains voltage corresponds to the voltage
specified on the unit body.
• Remove the water tank (16), fill it with cold
water till the MAX mark and install it back to
its place (pic. 1).
• Remove the milk tank (11), fill it with cold
water till the MAX mark as well and install it
back to its place (pic. 2).
•
Select one of the coffee filters (20 or 21), and
insert it into the holder (19), matching the
ledge on the filter with the hole on the holder
(19) and turn the filter clockw ise/anticlock
wise (pic. 3, 4).
•
Install the filter holder into the coffee maker.
Holder ledges (19) should match the groves
on the boiler (pic. 5) and then turn the filter
holder handle (17) to the right till bumping
(pic. 6, 7).
•
Place a corresponding cup on the respective
tray (3 or 5) and turn the cappuccinator pipe
(2) to the cup using the bar (8) (pic. 8).
•
Insert the power plug into the mains socket.
•
Switch the coffee maker on by pressing the
button (14), the illumination o f the buttons
(23, 24 and 25) on the control panel will start
flashing.
• When the illumination stops flashing, press
and hold the espresso button (23) for 3 sec
onds. Let the water run for 80-90 seconds.
•
Press the button (23) once again to switch
water supply off.
•
Select the washing mode “Cleaning” by tu rn
ing the frothed milk supply knob (9).
5
• Then press and hold the cappuccino b u t
ton (24) for 3 seconds. Let the water run for
80-90 seconds.
•
Press the button (24) once again to switch
water supply off.
•
The illumination of control buttons will light
up constantly, that means that the unit is
ready for operation and the boiler is clean.
Attention!
•
Do not remove the filter holder (19) during
the unit operation.
•
Do not remove the filter holder (19) im m e
diately after preparing coffee as there is
redundant water and steam pressure inside,
let the coffee maker cool down completely.
• To remove the filter holder (19) turn the han
dle to the left and remove the holder.
Choosing the appropriate cup
Drink
Estimated
volume o f the
ready product
Espresso
One cup
30-40 ml
Two cups
70-80 ml
Cappuccino
One cup
170 ml
Two cups
280 ml
Latte
One cup
340 ml
Two cups
430 ml
Note:
• The cups should be preliminary heated up,
to do this, put the cups on the tray (1) while
water heats up in the boiler.
Making espresso
•
Make sure that the unit is switched off.
•
Remove the water tank (16), fill it with cold
water and install back to its place (pic. 1).
•
Select one of the coffee filters (20 or 21), and
insert it into the holder (19), matching the
ledge on the filter with the hole on the holder
(19) and turn the filter clockwise/anticlock
wise (pic. 3, 4).
• Add ground coffee into the filter: 2 full mea
suring spoons - to make two coffee cups
and 1 full spoon - to make one coffee cup,
make even and slightly tam p the ground
coffee with the back side of the measuring
spoon (22).
V T -1 5 1 4 _ IM .in d d 5
07.12.2012 9:29:24