Vitek 113621, Manual Instruction

Page: 4 / 32

4
ENGLISH
•
Do not allow children to touch the unit body
and the power cord during operation.
• This unit is not intended for usage by children.
•
The unit is not intended for usage by physi-
cally or mentally disabled persons (including
children) or by persons lacking experience or
knowledge if they are not under supervision of
a person who is responsible for their safety or
if they are not instructed by this person on the
usage of the unit.
• Do not leave children unattended to prevent
using the unit as a toy.
• For children safety reasons do not leave poly-
ethylene bags, used as packaging, unat-
tended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger of
suffocation!
• Never pull the power cord when disconnect-
ing the unit from the mains; take the power
plug and carefully pull it out of the mains
socket.
•
Never use the unit if the power cord or the
power plug is damaged, if the unit works
improperly or after it was dropped.
• Do not attempt to repair the unit. Do not disas-
semble the unit by yourself, if any malfunction
is detected or after it was dropped, unplug
the unit and apply to any authorized service
center from the contact address list given in
the warranty certificate and on the website
www.vitek.ru.
•
Transport the unit in the original package
only.
• For environment protection do not discard the
unit with usual household waste after its ser-
vice life expiration; apply to a specialized cen-
ter for further recycling.
•
Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
BEFORE THE FIRST USE
After unit transportation or storage under
cold (winter) conditions, it is necessary to
keep it for at least three hours at room tem-
perature.
There may be water spots in the air humidi-
fier, this is normal, as the unit has undergone
factory quality control.
–
Unpack the unit, remove any stickers and
package materials that can prevent unit oper-
ation. Check the unit for damages. In case of
damages do not switch the unit on.
–
Before plugging the unit in make sure that
your home mains voltage corresponds to the
unit operating voltage.
Notes:
–
Use the air humidifier at the room tempera-
ture from +10° С to +40°С, and relative humid-
ity less than 80%.
–
Water temperature should not 40°С.
Installing batteries in the remote control (14)
•
Press on the lock and remove the battery
holder from the remote control (14), install a
CR2025 battery, strictly following the polarity.
• Install the battery holder back to its place.
Note: If there is an isolation insert in the remote
control battery compartment, remove the insert.
Battery replacement
•
Press on the lock and remove the battery
holder from the remote control (14), install
new CR2025 battery, strictly following the
polarity, and install the battery holder back
to its place.
USING THE AIR HUMIDIFIER
–
Remove the nozzle (3).
–
Turn the clamp handle (12) counterclockwise
until bumping.
–
Take the water tank by the handle (4) and
remove it from the unit body (13).
Notes:
–
use the handle (4) for carrying the water
tank (2) only;
–
do not use the handle (4) to carry the air
humidifier with the water tank (2) installed.
–
Turn over the tank (2), remove the lid (6) rotat-
ing it counterclockwise until bumping.
–
Fill the tank (2) with necessary amount of
water, insert the lid (6) into the water inlet (5)
and screw it rotating it clockwise until bump-
ing.
–
First place the filled water tank (2) back to its
place and then install the nozzle (3).
–
Fix the water tank (2) on the air humidifier
body (13) turning the clamp handle (12) clock-
wise until bumping.
–
Wait till the process chamber (9) is filled with
water.
IM VT-2336.indd 4 28.12.2016 17:46:12