MGW Ace Encoder
HEVC Encoding and Streaming Appliance
User Manual, Version 2.1
41
Target Section
Two targets are available from the same video channel. Select the
Target 1
or
Target 2
tab
accordingly, to specify and enable two different targets.
Parameter
Description
Channel Name
Enter the channel name. This name will also appear in Session
Announcement Protocol (SAP) messages.
Streaming Protocol
Select the streaming protocol.
Target Address
Enter the target IP address.
Target port
Enter the target port.
Multicast Interface
Select the network interface to stream from while using a multicast
target address.
In case, a unicast stream requires to be routed through a specific
Ethernet Port, refer to the Note below.
TTL
Enter the TTL value
Time-to-live (TTL) tells a network router whether or not the packet
has been in the network too long and should be discarded. Each time
an IP packet hits a router, TTL value is reduced by 1. If TTL remains
greater than 0, the router forwards the packet, otherwise it is
discarded.
Set a value high enough to ensure streaming packets are reaching
the decoder.
TTL value can be found by pinging the remote decoder.
The Value range is 1-255.
UDP Packet Size
Enter the UDP packet size value.
Some transmission link accepts only smaller UDP packet size. Reduce
the UDP packet size if experiencing decoding problems.
SAP
Select the SAP check box to enable Session Announcement Protocol.
Traffic Shaping
Select the Traffic Shaping check box to enable network smoothing.
Error Correction Settings Available with Zixi
TM
and Pro-MPEG mode. See details below.
CDN Settings
Available for RTMP mode (H.264). See details below.
