1
2
3
1.
Power Indication:
When the stop symbol (O) brightens, this indicates that the machine is plugged in
and power is flowing.
Before beginning any blending cycle, always make sure that the variable-speed
control is pointed at the stop symbol (O).
Unplug the machine whenever it will be left unattended.
The light at the stop symbol on the control panel will behave in these ways:
Slow flash
– the machine is plugged in but the container is not properly in place on the motor base
Solid (no flash)
– the machine is plugged in, the container is in place and the machine is ready to blend
Fast flash
– error caused by one of the following: (reset required, see instructions below)
A.
The motor base is plugged in while the variable-speed control is not in the stop position (O).
B.
The container was placed on the machine while the variable-speed control was not pointed at the
stop symbol (O).
C.
The container was removed from the machine while operating (could include lifting the container
away from the motor base and the interlock tabs losing contact with the base during tamping).
To Reset:
A.
Make sure that both interlock tabs on the container are fully seated in the cut-outs in the motor base.
B.
Turn the variable speed control anti-clockwise back to the stop symbol (O).
2. Variable-Speed Control:
Selects blade rotation speeds from 1 to 10 (low to high).
Always begin blending
with the variable-speed control set to the stop symbol (O)
. To begin, rotate the variable-speed control
clockwise to the desired speed setting. To stop, rotate the variable-speed control anti-clockwise back to
the stop symbol (O).
3. Pulse ( ):
Rotating the variable-speed control to the pulse position will cause the machine to blend
at 50% of high speed for as long as it is held in this position. The pulse feature can be used to chop
ingredients by quickly rotating the variable-speed control to the pulse position, releasing and repeating
until the desired consistency is reached.
4.
Programmes:
Rotating the control knob anti-clockwise from the stop symbol allows you to select
a programme. Programme blending speeds and duration vary and will stop automatically at the end of the
programme. To begin a programme, rotate to the icon and then press in on the centre of the control knob to
activate the blades. To stop, push in again on the centre of the control knob. Rotate the control knob back
to the stop symbol when finished.
2
c
o n t r o l
P
a n e l
S30
S50
2
S55
7
1
3
1
3
4
4
