V i t a l W e l l E l e c t r o n i c s P t e L t d
w w w . v i t a l - w e l l . c o m
- 10 -
E.g.: When S126=1or 3, the
‘
10=ABCD
’
inputs, will sent data
‘
ABCD
’
to address 10; when S126=2 or 3, the output
“
2=ABCD
”
means the data come from address 2.
R
Or
R/W
S127
Echo back
Ack to host
Indicates the acknowledgment handling method (Used for
Addressed/Transparent Secured Mode).
(Only the lower 4bits in this byte will be R/W. the upper 4 bits
is used by system to indicate the RF acknowledgment
status).
_ '0': No (Default),
OK or fail signal is not sent to Host
_ '1': OK or fail signal will be sent to host
By default, in case of problems, the modem will retry
automatically for the numbers (which set by register S125),
but doesn
’
t assert the signals to host. If enable, after each
successful transmission, a Synchronize byte (0x16) will be
sent out; if after retry still fail, a NAK byte (0x15) will be sent
to the host.
R/W
S128
Node Type
Node Type:
‘
0
’
: Normal node (not intent to route a message)
’
1
’
: Repeater node (This is a repeater, and will route any
message it received)
R/W
S129
Repeater
Enable
Repeater Enable control:
‘
0
’
: Disable
‘
1
’
: Enable
If S129 = 1, the TX package will automatically routed to & by
the repeater(address defined by S130)
R/W
S130
Repeater
Address
Repeater Address:
If S129 =1, this register will set the desired repeater
’
s
address. All Tx package will be send to this node first, and
the repeater will automatically route the package to the
desired destination.
