EN
18
Before Assembly
PLEASE NOTE!
■
Never remove the rating plate and any possible warnings!
1. Check the items supplied for completeness (see the "Items Supplied" chapter) and
possible transport damage. If you
fi
nd any damage to the components, do not use
them (!), but contact our customer service department.
2. Lay out all parts carefully on a
fl
at
fl
oor. To be on the safe side, place a protective
fi
lm
or blanket underneath the parts to prevent any damage to delicate surfaces.
3. Before using the device, remove all packaging materials and any labels that may be
on the device and are used for protection during transportation or for advertising.
Assembly
Follow these assembly instructions step by step to prevent any errors during set-up and
subsequent use:
1. Screw the feet onto the bottom of the device enclosure.
Use the fastening material supplied with the device to do
this. The smaller support bar should be at the front (below
the tension knob).
2. Turn the pedals tight on the pedal mounts using the span-
ner which is supplied. Make sure that the markings
L
(left)
and
R
(right) on the pedals and mounts match.
The right pedal (right-hand thread) is tightened in the
clockwise direction.
The left pedal (left-hand thread) is tightened in the
anticlockwise direction.
Adjusting the Pedal Straps
There is the option of adjusting the strap size on the pedal.
To do this, unscrew the cross-head screws on the pedals and
adjust the straps to the size you want. Then tighten the screws
so they are hand-tight again.
