17
EN
Remain lying on the massage mat for the time you want. We recommend that
you use each massage programme for no more than 15 minutes.
7. The device switches off automatically after approx. 15 minutes. For another massage
programme press the
AN / AUS
(on / off) on the controller button again.
8. Pull the mains adapter out of the plug socket and disconnect the barrel connector
from the device.
9. Allow the device to cool down if the heat function was activated before you put it away
or clean it (see the “Cleaning and Storage” chapter).
Cleaning and Storage
PLEASE NOTE!
■
Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the
device. These could damage the surfaces.
• Make sure that the device is not connected to the mains power and has cooled down.
• Clean the device only with a slightly damp cloth.
• When storing it away, do not press the device together too strongly and do not use
force. It could be damaged.
• Keep the device in its respective packaging in a dry place which is protected from
sunlight and is not accessible to children or animals.
Troubleshooting
If the device stops working properly,
fi
rst check whether you are able to correct the
problem yourself. If the problem cannot be solved with the steps that are listed, contact
the customer service department.
Do not attempt to repair a electrical device yourself!
Problem
Possible cause
Solution
The device does not
work.
The device is not receiving
any power supply.
Check whether
• all cables are correctly
connected to each other.
• the mains adapter is inserted
in the plug socket.
• the plug socket is defective.
• the fuse of your mains con-
nection has been activated.
The
AN / AUS
(on / off)
button has not been
(correctly) pressed.
Press the
AN / AUS
(on / off)
button and then activate a
massage zone.
All massage zones are
deactivated.
Press the button for a massage
zone to activate it. The associat-
ed LEDs light up.
