28
3.13.4 VIEW ANGLE SETUP
FLIP
: OFF,90 ,100 ,110 ,120 ,AUTO
OFF:
the dome camera moves until 90 vertically.
90 , 100 , 110 , 120 :
allows the image to flip digitally when the camera moves over the setting angle
vertically.
AUTO:
When the camera reaches the floor directly above the moving object, it will stop. At that time,
release the Joystick handle instantly and pull it down again to run the auto-flip function. When you use
the panning range, we recommend using the flip mode to AUTO.
TILT ANGLE LIMIT:
This option is used to set the limit of the horizontal view angle so that the trim ring or ceiling does not
obstruct the horizontal image when zooming out (wide angle).
TILT ANGLE LIMIT
is in the range of -10 to 10.
PANNING RANGE
If the Dome is installed close to a wall or public boundary whereby the camera needs to be restricted
from viewing this area then the panning range can be set up to stop this.
1.
Select ‘RIGHT LIMIT’. Press the
(IO/FN)
key, then
‘CTRL’ is displayed. Move to the desired position.
Press the
(IC/FF)
key then the
‘CTRL’ disappears.
2.
Select ‘LEFT LIMIT’. Press the
(IO/FN)
key, then
‘CTRL’ is displayed. Move to the desired position.
Press the
(IC/FF)
key then the
‘CTRL’ disappears.
3.
Select ‘ENABLE’. Set to ON - adjust with
(TELE/WIDE)
4.
Select ‘SWAP’. Set to ON, to swap the start RIGHT & LEFT LIMITS - adjust with
(TELE/WIDE)
5.
To save changes highlight ‘SAVE AND EXIT’ and move
Joystick
right.
Joystick
left exits without
saving.
To exchange the right and the left limit, set SWAP to ON.
To apply limits on the auto pan (endless panning), set AUTO PAN to ON.
VIEW ANGLE SETUP
PANNING RANGE
FLIP
: 90
TILT ANGLE LIMIT : 00
SAVE AND EXIT(ESC TO CANCEL)
PANNING RANGE SETUP
(CTRL KEY)
RIGHT LIMIT : 000.0
LEFT LIMIT : 000.0
ENABLE : OFF
SWAP : OFF
AUTO PAN : OFF
SAVE AND EXIT(ESC TO CANCEL)
Summary of Contents for VP960H
