7
Qty System parts
Image
1
1
Cable IEC 5m Extension
1
Cable Power 2m
1
Cable RJ45 3m
1
Telescopic arm (monopod)
A48
The whole rail is assembled on the floor. The 1.5-m pieces are attached to one
another with suspension plates for firm alignment and electrical connection.
1.
Align the aluminium rail pieces on the floor. Put the rail piece with the end
stop closest to the goniometer. Put the rail piece with the injector module
farthest away from the goniometer.
2.
Push the connector profiles into the grooves in the rail
–
4 at each of each
rail pieces: 2 on the top and two in the bottom grooves.
3.
Start by joining the rail pieces on the bottom side of the rail:
Use the grub
screws M5x6 to fasten the connector profiles into the rail grooves.
Push the rail pieces tightly together.
4.
Turn the rail up-side-up.
5.
On the top side: Use the
M5x6 screws to the suspension plates to the
rail pieces
–
2 screws into every connector profile.
