DQ Technology, Inc. / VisionNet
Page 34
M605N User Manual Revision 3.1
Step 2: Configuring the WAN Service
2.A
WAN SERVICE CONFIGURATION.
Select WAN
Service Type:
PPPoE
Enter Service
Description
Will not affect service –
no spaces allowed
802.1P Tag
(Only for VLAN
Mux Services)
-‐1 Untagged
Otherwise, choose
appropriate tag
802.1Q Tag
(Only for VLAN
Mux Services)
-‐1 Untagged
Otherwise, choose
appropriate tag
2.B
Select
“Next”
and Proceed to “PPPoE Username and Password”
PPP Username
Enter unique Username
PPP Password
Enter unique Password
PPPoE Service
Name
Leave blank unless specified
by your Network Ops
Manager
Authentication
Method
AUTO unless specified by
your Network Operations
Manager
MTU
1492 unless specified by
your Network Operations
Manager
Enable NAT
Enabled, unless otherwise
specified by Network
Operations
Enable Full-‐Cone
NAT
Disabled, unless specified
otherwise by Network
Operations
Dial on Demand
Disabled unless specified
otherwise by Network
Operations
PPPIP Extension
Disabled unless specified
otherwise by Network
Operations
Use Static IPv4
Address
Only use for static IP
Settings
Enable PPP
Debug Mode
Disabled – this is only for
sending PPP packets to the
Syslog for temporary
troubleshooting
Bridge PPPoE
Frames
Disabled – this will allow
Clients to tunnel through
the firewall to create a
second PPPoE Session
MultiCast Proxy
Disabled unless specified
otherwise by Network
Operations
2.C
Routing – Default Gateway
