M
AINTENANCE
V
ISIONEER
®
R
OAD
W
ARRIOR
4D
S
CANNER
U
SER
’
S
G
UIDE
29
Error Codes
If your scanner experiences a hardware error, the status light will blink red. It will flash in a numerical sequence,
pause, then repeat the same number of flashes. The number of times the light blinks between pauses indicates
the error code number. The following table describes the error codes.
V
ISIONEER
®
R
OAD
W
ARRIOR
4D S
PECIFICATIONS
Error Code
Problem Description
Solution
4
Paper jam
Open the scanner and remove the jammed document.
6
Cover open
Make sure the scanner is fully closed after performing
maintenance on the scanner or removing a jammed page.
If needed, open and close the scanner again. If the
problem persists, try power cycling the scanner through
un-plug and re-plug of the USB cable.
8
Calibration error
This may occur if the USB cable was unplugged during
calibration, the calibration was canceled, or the calibration
page was not used.
First, power cycle the scanner through un-plug and re-
plug of the USB cable, and then restart the calibration
routine. Please refer to
Calibrating Your Scanner
on
page 24 for instructions.
Make sure you have the scanner’s calibration page ready
when you start the calibration utility.
Scanner Specifications
Document Requirements
Minimum Item Size
1.5 x 1.5 inches (38 x 38 mm)
Maximum Item Size
8.5 x 32 inches (216 x 813 mm) at 100–300 dpi
8.5 x 14 inches (216 x 356 mm) at 400–600 dpi
Paper Thickness
16–32 lbs. (60–120 g/m
2
)
Plastic Card
Non-Embossed cards up to 0.8 mm thick
General Specifications
Scanning Speed (ADF)
8 SPP (seconds per page) @ 300 dpi
a
Optical Resolution
600 dpi
Output Bit Depth
24-bit color, 8-bit grayscale, 1-bit bitonal (black & white)
Scan Method
Duplex single sheetfed
Image Sensor
Contact Image Sensor (CIS)
Light Source
RGB LED lamp
Interface
Hi-Speed USB 2.0
