Vision VR48 4 Series, User Manual

Page: 14 / 352

Vision VR48 Series 4 Router User Manual 14
© 2015 Vision Engraving and Routing Systems
2 General Information - Installation
2.1 Requirements
Electrical Connections
1. A qualified and licensed electrician must be used to complete all wiring and grounding of the
machine according to all state, local, and national electrical codes.
2. Make sure all Junction Boxes and Outlets are mounted according to all state, local and national
electrical codes.
3. Junction Box #1 (50 Amp, 220 VAC, Single Phase) will power the router table, spindle, and controls.
It is typically mounted on Wall A, approximately 36 to 48 inches above the floor surface. The box
should be level with the left edge of the router table. (Refer to Installation Layout Diagrams).
4. Junction Box #2 - for machines equipped with Vacuum Tables ONLY - (40 Amp. 220 VAC, 3 Phase)
will power the Vacuum Pump. Mounting should be on Wall A and between 36 inches and 48 inches
above the floor surface. If locating the vacuum pump as shown (Refer to Installation Layout
Diagram), locate Junction Box #2 no greater than 4 feet from Junction Box #1.
5. Outlet #1 (20 Amp, 220 VAC, Single Phase or 25 Amp, 110 VAC) should be mounted on Wall A as
shown (Refer to Installation Layout Diagram - Section 2.1). This can also be another Junction Box if
the Dust Collector is to be direct wired to its electrical source. The dust collector is approximately 2
feet x 3 feet and is on wheels.
6. Outlet #2 (15 Amp, 110 VAC, Single Phase) should have multiple standard three prong sockets for
the computer. It is typically located near the bottom left corner of the router table (home position) as
shown (Refer to Installation Layout Diagram).
7. Wiring needs to be completed to the junction boxes, outlets, etc. before the scheduled first
installation/machine orientation day.