Vision VR48 4 Series, User Manual

Page: 111 / 352

The DACS Camera System 111
© 2015 Vision Engraving and Routing Systems
6.2.3 Ethernet Camera Software Setup
IMPORTANT NOTE: The Ethernet DACS camera requires the VR48 Router to be connected to
your computer or network via a STATIC IP Address. Please refer to the sections of this manual
regarding connecting your router using a Static IP Address, or call Vision technical support -
602-439-0700.
To begin setting up the Ethernet Camera, first, turn the power on to your machine and wait until it has
initialized. Press Go to Limits on the Pendant. Make sure the 3' Ethernet cable and camera power cable
(also supplied) are both connected from the right side of the router's carriage to the top of the DACS
camera (port locations shown below). NOTE - Refer to the Using a Network Hub section of this Manual
in order to properly set up the connection between your computer and the router, using a network hub.
Connect an Ethernet cable from the supplied network hub to the DACS Ethernet Port on the left side of
your Vision VR48 Router with the supplied 15' Ethernet cable.
See next page for port locations on the machine's Electronics Box.