Vision Multi Axis, Operation Manual

Page: 7 / 41

Chapter 2 - Installation 7
Chapter 2 - Installation
Hooking up the table
There are two connections that must be made on the MAX Engraver table. One is a large 25 pin table cable and the other
is a 9 pin cable for the rotary axis. There are also two connections that must be made on the Vision Series 3 Controller.
For detailed instructions on the connections for the Vision Series 3 Controller, please see the controller manual.
Locate the table cable connection box shown in figure 2.1 below.
(Figure 2.1) The table cable connection box
Plug the 25 pin cable into the table cable connection box as shown in figure 2.2 below. Make sure to tighten the two
table cable tightening screws shown below.
Caution:
Do not overtighten the cable tightening screws.
(Figure 2.2) The table cable tightening screws