Vision Multi Axis, Operation Manual

Page: 23 / 41

Chapter 3 - Operations 23
When you send a job to the engraver from Vision, make sure that you select the MaxR machine driver and when you send
the job from Vision Pro, make sure that you select the Max Rotary Engraver machine driver. Using a driver other than
these may result in the object not engraving properly. You must enter in the diameter of the object you are engraving on
the engrave screen in Vision or Vision Pro.
Adjusting the Spindle
Diamond Drag Engraving
In this section, we will set up the spindle for engraving with a non-rotating cutter, such as a diamond drag cutter. Figure
3.20 below shows the spindle with the optional diamond drag adapter and how to install the adapter.
(Figure 3.20) The MAX Engraver spindle with diamond drag adapter
Spindle Pulley
Spindle Housing
Pointer
Micrometer
Retainer Ring
Nose Cone
Diamond
Drag Adaptor
To install the diamond drag adapter, you must first remove the retainer ring and nose. To do this, unscrew the retainer
ring from the micrometer. Next, screw the diamond drag adapter onto the micrometer. Make sure that the micrometer is
screwed up tight to the pointer.