VISION X
FEATURES
1. Lightweight hybrid housing.
2. Integrated electronic thermal management (ETM).
3. Single 100 watt LEDs produce 3,500’ of usable light.
8.7” CG2 LED LIGHT CANNON SPECIFICATION
1. Warranty
: Extended
2. Amp Draw
: 8.3A @ 12V DC
3. Input Voltage
: 9-32V DC
4. Beam Patterns : 10°, Snap-On Filters Available
5. LED Lifespan
: 50,000 Hours
PREPARATION
1. We recommend completely reading instructions before
installing.
2. Consult your local state regulatory agency regarding the
use of LED lighting.
3. The placement of LED lighting should not restrict airfl ow to
the radiator, or block head lamps, turn signals, or parking
lights.
About The 8.7” CG2 LED Light Cannon:
1
2
3
Qty: 1
Qty: 1
CG2
Cannon
Hex Head Bolt
[M12]
LIGHT
PART (P1)
Qty: 1
PART (B1)
4
Qty: 1
Washer
[M12]
PART (W1)
5
Qty: 1
Nylock Nut
[M12]
PART (N1)
Pigtail
8.7” CG2 LED LIGHT CANNON
WARNING: Bolts, Nuts, and Washers are Stainless Steel.
DO NOT USE Pneumatic or Electric Tools to Tighten and
Loosen. The Hardware Will Permanently Lock Together.
(B1)
(Mounting Bracket)
(W1)
(N1)
MOUNTING KEY
Part (B1) Bolt
Part
(Mounting Bracket)
Part (W1) Washer
Part (N1) Nut
MOUNTING DIAGRAM
MOUNTING INSTALLATION INSTRUCTION
1. Determine where the light/lights will be placed.
2. Place mounting bracket with light to desired location. Using
a marker or pick tool, mark the center point of the bolt hole
on the mounting surface.
3. Set the light aside. Drill out a large enough hole to fi t the
[M12] bolt Part (B1).
4. Line up the mounting bracket with the hole you just drilled,
slide the [M12] Bolt (B1) through both.
5. On the other side of mounting surface slide the [M10]
Washer Part (W1) and [M12] Nylock Nut Part (N1) onto the
[M12] Bolt (B1). Tighten Nut & Bolt to desired tightness.
WIRING INSTALLATION INSTRUCTION
1. Supplied with the Light Cannon is a 3” Pigtail.
2. Connect the positive (red) wire and negative (black) wire
into an existing power source.
