Trimline 70 SL
19
AR glass (Anti-Reflective glass) cleaning
instructions
General
AR glass is a non-reflecting ceramic glass. This glass has an
AR coating on both sides of the glass. The anti-reflection layer
reduces the reflection to a minimal gloss. It is a known fact
that the coating layers are more sensitive than the ceramic,
therefore it is necessary to follow special cleaning procedures.
Important
Do not use any of the following cleaning agents:
•
Hard or abrasive sponges, steel wool, abrasives
•
Cleaning agents with ammonia or acid (even citric acid)
•
Paper towels, ceramic hob cleaner.
Only use water or a suitable detergent surfactant
We recommend our thermoCet Cleaner.
Remove frame with glass pane
See Paragraph
2.2 Preparation and placement
on page 3.
Important
After the first use, there will be a white haze on the inside of the
glass pane; this white haze must be removed immediately after
the first use when the unit has cooled down.
The higher the frequency of use, the more often cleaning is
required. After more frequent use, more frequent cleaning of
the glass will be necessary. By not cleaning the glass in time,
it will become dull and increasingly difficult to clean.
Information
If a unit with AR glass is placed near windows, or if there is a
lot of light on the glass, it is possible the reflection of bright
colours will be seen. For example, the AR glass may reflect the
colours from a red sofa, white table or a floor.
If the AR glass is cleaned regularly, or by frequently using
products that are not recommended, the AR effect will fade
over time.
