Date of last revision: 2.06
ENGINEERING
GUIDES
TREADMILL.PREMIERENG.REV2
8
USER ENGINEERING MODE
(Models T9700S, T9700HRT, & PREMIER Only)
P17 - ELEVATION ERRORS
P17 allows you to clear an elevation error. This will allow you to operate the Treadmill without elevation. Press and
hold
“SELECT”
to clear.
P18 - SCROLL SPEED
P18 represents the text speed for the alphanumeric display. The default number is 2. You can change the text speed
by using the down arrow to change the number from 1 to 5. One is the fastest and five is the slowest. Press and hold
“SELECT”
to enter.
P19 - DECK LUBRICATION MESSAGE (T9700S & T9700HRT ONLY)
P19 represents whether the service message for deck lubrication has been enabled. If enabled, a "1" appears in the
alphanumeric display. Otherwise, a "0" appears if disabled. To disable the message, you must press one of the
“SPEED”
keys so that a "0" appears in the right window. Then press
“SELECT”
to save prior to exiting. To exit, press
“STOP”
.
P20 - CLEAN TREADMILL MESSAGE (T9700S & T9700HRT ONLY)
P20 represents whether the service message for clean treadmill has been enabled. If enabled, a "1" appears in the
alphanumeric display. Otherwise, a "0" appears if disabled. To disable the message, you must press one of the arrow
keys so that a "0" appears in the right window. Then press
“SELECT”
to save prior to exiting. To exit, press
“STOP”
.
P21 - CHECK MOTOR BRUSHES MESSAGE (T9700S & T9700HRT ONLY)
P21 represents whether the service message for check motor brushes has been enabled. If enabled, a "1" appears in
the alphanumeric display. Otherwise, a "0" appears if disabled. To disable the message, you must press one of the
arrow keys so that a "0" appears in the right window. Then press
“SELECT”
to save prior to exiting. To exit, press
“STOP”
.
AUTO-CALIBRATION
(Models T9700S, T9700HRT, & PREMIER Only)
DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION!
You need to access User Engineering Mode to run the Auto-Calibration. To access this mode, please hold down
“SPEED
DOWN”
and
“SELECT”
for 5 seconds. When in the User mode,
""UUSSEERR EENNGG""
appears in the alphanumeric
window. Press
“SELECT”
. To access the data press either set of arrow keys until
""AAUUTTOO--CCAALLIIBBRRAATTIIOONN""
appears. Press
“SELECT”
.
To begin auto-cal, press
“START”
. The Treadmill will run through minimum and maximum speed and maximum incline.
This will take 3-5 minutes. Let the Treadmill perform this complete function before exiting the Engineering Mode.
""EENNDD""
will appear when the auto-calibration is complete. The Treadmill will come to a complete stop and return to the
start-up screen in the alphanumeric window.
P22 - EXIT USER ENGINEERING MODE
P22 represents exit mode. When you press
“SELECT”
, the console performs a reboot, returning to program setup.
Premier Upper Board: Engineering Guide
