Vision Engraving & Routing Systems VR48 5 Series, Installation Manual

Page: 13 / 54

Machine Setup 13
© 2020 Vision Engraving & Routing Systems
2.2.3 Connections
The Main Power Switch is located on the left side of the VR48.
The main power supply is connected to the Main Electrical Box on the left side of the VR48. Remove the
cover (if installed) and make the connections as shown below. Ground is connected to the bare wire and
common leads are connected to the two shielded wires. The supply for this connection is Junction Box
#1 (220 VAC, Single Phase). NOTE: If the 5 hp router spindle is purchased, 220 VAC, Three Phase
power is needed).
Note: The picture below is for illustration purposes only. The power cable should enter the Main Electrical
Box through the hole in the left side of the box as shown in the above picture.