Instruction Manual – Verdanium Geo – Ver. 1.1.1 – 12.2021
Instruction Manual – Verdanium Geo – Ver. 1.1.1 – 12.2021
36
37
Before installing the withdrawal tap, determine its installation point.
•
The withdrawal tap should be in an easy-to-use place. Please pay attention to the rotation
of the existing faucet.
•
Measure the thickness of the tabletop (40 mm max.).
•
Consider the installation and connection options under the sink.
For the bore required in the countertop or the sink, please use drill sizes 3 mm, 7 mm and 12 mm. Start with
the smallest diameter and low drill RPM and increase the speed slowly.
Use a round file to clean the bore and remove any burr residues. For installation of the withdrawal tap into
stone tabletops or sinks, (granite, marble etc.), please follow the drilling regulations of the manufacturer.
Please use the illustration below as a reference for the installation of the withdrawal tap and proceed as
follows:
•
Insert the supplied parts in the correct order on the threaded tube.
•
Correctly align the withdrawal tap.
•
Install the withdrawal tap by tightening the wing nut.
Both connections to the angle valve and the Verdanium Geo are under full water pressure
and should be installed with particular care. Check that both connections, with the angle val-
ve opened, are leak-proof.
Withdrawal tap
Withdrawal tap
To
Verdanium
Geo
Plastic tube 1/4“
Art.-Nr.: PE-08-BI-0500F-N
Connection adapter 1/4“
Wing nut
Large plastic ring washer
Tap base
Tabletop
Waterspout
Thread
