Viscount UNICO CL7, User Manual

Page: 25 / 38

23
Viscount
UNICO
8
-
7
/ /
User Guide
Functioning of different modes is described in the tables below.
With 4 audio outputs:
MODE OUTPUTS 1-2 OUTPUTS 3-4
STANDARD
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
GENERAL-REVERB General signal Reverberated signal only
With the expansion kit of 12 audio outputs installed:
NOTE
Without the optional kit for 12 audio outputs installed, it is not possible to configure the registers
output router in the EXTERNAL OUT ROUTER function selecting the REVERB outputs
mode.
MODE OUTPUTS 1-8 OUTPUTS 9-10 OUTPUTS 11-12
TAB AMPLIFICAT.
[CONSOLE ON]
TAB AMPLIFICAT.
[EXT. SPEAKER ON]
STANDARD
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
Internal amplification Outputs 1-12
GENERAL-REVERB
As set in Ext. Router
Conf. function.
General signal Reverberated signal only Outputs 1-8 Outputs 9-12
ANTIPHONAL
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
Outputs 1-8 Outputs 9-12
GENERAL-ANTIPH.
As set in Ext. Router
Conf. function.
General signal
As set in Ext. Router
Conf. function.
Outputs 1-8 Outputs 9-12
ANTIPH.-REVERB
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
Reverberated signal only Outputs 1-8 Outputs 9-12
9.2 CONFIGURING THE AUDIO OUTPUTS ON THE REAR (EXT. OUT
CONFIG function)
Thanks to this function, the PROGRAMMABLE OUTPUTS can be configured, so as to manage the
Antiphonal signal (controlled through the AMPLIFICATION tabs), the general signal or just the reverberated
signal of the instrument. Select the EXT. OUT CONFIG. field under the SET-UP menu; this pop-up message
will appear:
which means that the external panning (see par- 9.1) of certain stops might be modified automatically.
Stops placed between outputs [2] and [3] or [8] and [9] (with the optional of 12 outputs installed) will be
automatically set as Mono on the first output of the previously configured panning.
Press [EXIT] to abort the automatic panning adjustment and return to the SET-UP menu.
Press [ENTER] to confirm - the display will show: