Visage Lighting & Effects
www.batmink.co.uk
IMPORTANT OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE OF INSTALLTION,
including
(but not limited to):
•
calculating working load limit
•
periodic safety inspections of all installation materials being used with the device
•
safe install areas out of reach of people if the device is lowered from the ceiling or high points
•
professional trussing systems must always be used with secure clamps
•
secure installation to ensure the device does not swing freely
•
the use of safety rope at least 12 times the weight of the fixture
•
A maximum drop distance never exceeding 20cm
FIRE SAFETY
Connection cables are as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
INSTRUCTIONS FOR USE
DMX – 512 connection.
Wires must not meet each other, otherwise only use a stereo shielded cable
and 3-pin XLR plug and connector in order to connect the controller with the fixture, or one fixture
with another XLR connector.
DMX-input
DMX-output
XLR mounting - socket XLR
XLR mounting - socket:
1. Ground
1. Ground
2. Signal(-)
2. Signal(-)
3. )
3. )
When using controllers with this device you can connect the DMX output of the controller directly
with the DMX input of the first fixture in the DMX chain. If you wish to connect DMX controller with
other XLR outputs you will need to use an adapter cable.
Building a serial DMX chain.
Connect the DMX output of the first fixture in the DMX chain with the
DMX input of the next fixture. Always connect one output with the input of the next fixture until all
fixtures are connected.
Operational Modes:
The Multipar has seven modes of operation, manual dimmer colour mode, sound active mode, auto
run mode, static colour mode, program select mode, slave mode and DMX mode.
