Visage Lighting & Effects
operation, it is absolutely necessary for the user to follow the safety instruction and warning notes
written in this manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. Batmink
Distribution will not accept liability for any resulting defect or problem. Please ensure you follow the
health and safety recommendations below when using the PAR 64-TRI 9-6 IN 1:
If the device has been exposed to temperature fluctuation (e.g. after transportation), please
do not switch it on immediately. Fluctuating temperatures may cause damage to your device.
We recommend that you leave your device switched off until the product has maintained
room temperature
Please make sure that there are no obvious transport damage. Should you notice any damage
on the A/C connection cable or on the casing please contact Batmink Distribution
Please handle the power cord with care. Never modify, bend, strain mechanically, put
pressure on, pull or heat up the power cord
If an extension cord is required, make sure that the core diameter is sufficient for the required
power consumption of the device
Always disconnect from the main power source when the device is not in use or before
cleaning it
Please ensure you keep this device clean and in good condition. If the power plug or the device
is dusty, the device must be taken out of operation, disconnected then be cleaned with a dry
cloth. Dust may reduce the insulation which could cause an electric shock. More severe levels
of dirt in the device should be removed by a specialist
Please ensure you keep this device away from liquids or fluctuating temperatures that may
cause condensation. If the device is on contact with any liquid, please disconnect the device
from the main power source immediately and leave to dry out before using again. If there is
any damage to the device please consult a specialist
HEALTH WARNING
Never look directly into the light source as this may cause damage to eyes.
Keep away from children and amateurs.
Never leave this device running unattended.
OPERATING & INSTALLATION CONSIDERATIONS
This product is only allowed to be operated with an alternating voltage of 90V/240V,50/60 Hz
and was designed for indoor use only. This device is designed for professional use (e.g. on
stage in discotheques, theatres etc.)
Please do not leave this device running for longer than recommended to ensure the device
operates efficiently for future use
If used in conjunction with a smoke machine make sure that the device is never exposed to
the direct smoke jet and is installed in a distance of 0.5 meter between the smoke machine
