ENGLISH
EN
10
• Lift the treadmill up towards the frame to fold the treadmill
• Secure the treadmill to the frame by tightening the Side Knob
(25) on the left upright tube
Unfolding
• Loosen the Side Knob (25) on the left upright tube.
• Unfold the treadmill by pushing the treadmill downwards.
• Pull up the Adjuster and tighten the Locking Knob (24) to lock
the treadmill in the correct position.
SAFETY KEY
Remove the safety key for an emergency stop. The treadmill stops
slowly and "Err" appears on the display. Replace the safety key and the
display shows "OFF".
TRAINING WITH HEART RATE
Hand
sensors
This VirtuFit fitness machine is equipped with hand sensors to measure
heart rate. The hand sensors are attached to the handle and only work
if both sensors are held for a long time. For optimal performance, it
is important that the hands are slightly damp and exert constant
pressure on the sensors. Hands that are too dry or too wet may result
in abnormal readings.
MAINTENANCE
Safe and efficient use can only be achieved if the appliance is
properly installed and maintained. It is your responsibility to ensure
that the appliance is maintained regularly. Parts that have been
used and/or damaged must be replaced before the appliance is
used again. The appliance should only be used and stored indoors.
Long-term exposure to weather and temperature/humidity changes
can have a serious impact on the electrical components and moving
parts of the unit. Always unplug the power cord from the unit before
cleaning or servicing it.
Daily maintenance
• Clean and remove sweat and moisture after each use.
Hex head bolts:
Make sure that the hex head spanner is pushed into
the bolt before applying force. This will prevent the head of the socket
bolt from turning.
ADJUSTING
Adjusting
1.
The treadmill veers to the left:
Turn on the treadmill, set the
speed to 2 to 3 km/h without forcing. Use the Allen key to turn
the screw on the left side of the end of the treadmill a quarter
turn to the right (1). Run the treadmill for 1 to 2 minutes without a
load. Repeat the process until the treadmill is exactly in the
middle.
2.
The treadmill turns to the right:
start the treadmill, set the
speed to 2 to 3 km/h without a load on the treadmill. Using the
hexagonal key, turn the screw on the right side of the end of the
treadmill a quarter turn to the right (2). Run the treadmill for 1 to
2 minutes without a load.
3.
The treadmill has jammed:
Use the Allen spanner to turn the
screw on the right side of the end half a turn to the right and
the screw on the left side of the end half a turn to the right as
well. Repeat the process until the blockage is resolved (3).
EN
Virtufit Totally Foldable TR-50i Treadmill
11
11
NL
INKLAP INSTRUCTIES
-- Pull the pull-pin on the console handrail to fold the console carefully.
-- Pay attention to the cables and ensure that they are nog pinced.
--unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up
--Place the machine leaning against the wall or place under a bed.
CAUTION: Do not allow children to touch the machine, the treadmill may fall.
FOLDING INSTRUCTIONS
1. Pull the pull-pin on the console handrail to fold the console carefully. Pay attention to the cables and
ensure that they are nog pinced.
2. Unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up.
3. Place the machine leaning against the wall or place under a bed.
NOTE:
Store your machine in a dry area away from children and high traffic areas as shown in the
illustration. Be sure it is secure and cannot fall onto small animals or children.
RUNNING BELT ADJUSTMENT
01. Running belt deviates to left: Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 1). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
02. Running belt deviate to right:
Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 2). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
03. Running belt jam: If the running belt is in dead condition, use the Allen key to turn the screw 1/2 a
turn both left and right until the jam solved (see fig 3).
EN
Virtufit Totally Foldable TR-50i Treadmill
11
11
NL
INKLAP INSTRUCTIES
-- Pull the pull-pin on the console handrail to fold the console carefully.
-- Pay attention to the cables and ensure that they are nog pinced.
--unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up
--Place the machine leaning against the wall or place under a bed.
CAUTION: Do not allow children to touch the machine, the treadmill may fall.
FOLDING INSTRUCTIONS
1. Pull the pull-pin on the console handrail to fold the console carefully. Pay attention to the cables and
ensure that they are nog pinced.
2. Unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up.
3. Place the machine leaning against the wall or place under a bed.
NOTE:
Store your machine in a dry area away from children and high traffic areas as shown in the
illustration. Be sure it is secure and cannot fall onto small animals or children.
RUNNING BELT ADJUSTMENT
01. Running belt deviates to left: Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 1). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
02. Running belt deviate to right:
Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 2). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
03. Running belt jam: If the running belt is in dead condition, use the Allen key to turn the screw 1/2 a
turn both left and right until the jam solved (see fig 3).
EN
Virtufit Totally Foldable TR-50i Treadmill
11
11
NL
INKLAP INSTRUCTIES
-- Pull the pull-pin on the console handrail to fold the console carefully.
-- Pay attention to the cables and ensure that they are nog pinced.
--unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up
--Place the machine leaning against the wall or place under a bed.
CAUTION: Do not allow children to touch the machine, the treadmill may fall.
FOLDING INSTRUCTIONS
1. Pull the pull-pin on the console handrail to fold the console carefully. Pay attention to the cables and
ensure that they are nog pinced.
2. Unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up.
3. Place the machine leaning against the wall or place under a bed.
NOTE:
Store your machine in a dry area away from children and high traffic areas as shown in the
illustration. Be sure it is secure and cannot fall onto small animals or children.
RUNNING BELT ADJUSTMENT
01. Running belt deviates to left: Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 1). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
02. Running belt deviate to right:
Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 2). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
03. Running belt jam: If the running belt is in dead condition, use the Allen key to turn the screw 1/2 a
turn both left and right until the jam solved (see fig 3).
FOLDING INSTRUCTIONS
NOTE!
Store the Folding Exercise Bike in a dry place, out of reach
of children, as shown in the diagram. Make sure the folding exercise
bike is stable and secure to prevent it from falling on pets or children.
ADJUSTER
Folding
• Loosen the Locking Knob (24) and pull the Adjuster downwards.
