EN
VirtuFit Indoor Cycle S1 Spinbike
14
Display does not work
If the display no longer works, you can replace the batteries. These are at the back of the display.
Display shows no values
If the display does not show any values, you can try to check the sensor cables and the cables in the back
of the display. If this still does not work, you can move the sensor slightly.
Spinbike beeps
Check that all bolts and nuts are tightened securely. Spray silicone spray if necessary.
Ticking sound when pedaling
This is probably caused by one of the trappers. Disassemble the pedal (s) and then re-assemble them on the
device. Be careful, the left trapper must be turned counterclockwise to secure, the right trapper clockwise.
Tighten the pedals firmly. Should this not be the case offer a solution, report this to the supplier.
The console is not working
If there is no signal when pedaling, check that the cable is properly attached.
PROBLEM SOLUTIONS
TROUBLE SHOOTING
