EN
VirtuFit Indoor Cycle S1 Spinbike
16
FUNCTION
CONTROL PANEL
FUNCTION
EXPLANATION
SCAN
TIME-DISTANCE-CALORIES-PULSE-RPM / SPEED change automatically every 6
seconds.
SPEED
The speed is displayed during training when you start training.
RPM
Revolutions per minute.
TIME
The total cycling time from the beginning to the end of the exercise is displayed.
If no signal is sent to the monitor for 4 seconds during training, the time stops.
DISTANCE
The distance of each workout is displayed when you start training. If a distance
target is set, it runs from the set distance to 0 and an alarm sounds.
CALORIES
The total calories from the beginning to the end of the exercise is displayed. If a
calorie goal is set, the calorie count decreases from the goal to 0 and an alarm
sounds.
PULSE
Current heart rate is displayed after 6 seconds, when the 5 kHz chest strap is
detected. If no heart rate signal is detected after 6 seconds, a “P” appears on the
display. An alarm sounds if your heart rate is higher than your target heart rate.
Range: 0-30 ~ 230 BPM.
If no signal has been sent to the display for more than 4 minutes, it
will go to SLEEP.
• The recovery function only works if the heartbeat becomes
detected.
• TIME starts at 0:60 seconds and ends at 0:00. After countdown
is on the display F1 to F6. In this way the recovery capacity of
your heart tested. On below schedule you can view your
recovery capacity.
• If you press RECOVERY again, you will return to the get started.
F1
Outstanding
F2
Excellent
F3
Good
F4
Fair
F5
Below average
F6
Poor
