Virtium StorFly 25PE, Product Manual

Page: 18 / 30

Product Specification
StorFly 25
VSFA25PxxxxG-xxx
Rev: 1.0
Tel 949.888.2444
–
30052 Tomas, Rancho Santa Margarita, CA 92688 USA
–
www.virtium.com
18
Word O/M F/V Value Description
V
V
F
F
F
F
F
F
F
V
V
V
F
F
11 Reserved for technical report-
10 1 = URG bit supported for WRITE STREAM DMA EXT and WRITE
STREAM EXT
9 1 = URG bit supported for READ STREAM DMA EXT and READ
STREAM EXT
8 1 = 64 bit World wide name supported
7 1 = WRITE DMA QUEUED FUA EXT command supported
6 1 = WRITE DMA FUA EXT and WRITE MULTIPLE FUA EXT commands
supported
5 1 = General Purpose Logging feature set supported
4 1 = Valid CONFIGURE STREAM command has been executed
3 1 = Media Card Pass Through Command feature set enabled
2 1 = Media serial number is valid
1 1 = SMART self-test supported
0 1 = SMART error logging supported
88
O F
V
V
V
V
V
V
V
F
F
F
F
F
F
F
F
047Fh
15-13 Reserved
14 1 = Ultra DMA mode 6 is selected
0 = Ultra DMA mode 6 is not selected
13 1 = Ultra DMA mode 5 is selected
0 = Ultra DMA mode 5 is not selected
12 1 = Ultra DMA mode 4 is selected
0 = Ultra DMA mode 4 is not selected
11 1 = Ultra DMA mode 3 is selected
0 = Ultra DMA mode 3 is not selected
10 1 = Ultra DMA mode 2 is selected
0 = Ultra DMA mode 2 is not selected
9 1 = Ultra DMA mode 1 is selected
0 = Ultra DMA mode 1 is not selected
8 1 = Ultra DMA mode 0 is selected
0 = Ultra DMA mode 0 is not selected
7 Reserved
6 1 = Ultra DMA mode 6 and below are supported
5 1 = Ultra DMA mode 5 and below are supported
4 1 = Ultra DMA mode 4 and below are supported
3 1 = Ultra DMA mode 3 and below are supported
2 1 = Ultra DMA mode 2 and below are supported
1 1 = Ultra DMA mode 1 and below are supported
0 1 = Ultra DMA mode 0 is supported
89 O F 0003h Time required for security erase unit completion
90 O F 0000h Time required for Enhanced security erase completion
91 O V 0000h Current advanced power management value
92 O V FFFEh Master Password Revision Code
93
F
F
V
F
V
0000h
Hardware reset result. The contents of bits (12:0) of this word shall change only
during the execution of a hardware reset.
15 Shall be cleared to zero.
14 Shall be set to one.
13 1 = device detected CBLID-above ViH
0 = device detected CBLID-below ViL
12-8 Device 1 hardware reset result. Device 0 shall clear these bits to zero. Device
1 shall set these bits as follows:
12 Reserved.