6
Remove the brush from its housing:
Replace with a new brush (part no. 753066), replace the protective cover and grid.
Taking up shaft slack
This operation must be carried out if forward and backward play is noted in the motor shaft.
Tighten up the rear chuck main shaft blind collar using a 5mm spanner until the play
disappears:
Replacing the cutter wheel
The cutter wheel must be replaced if it shows signs of wear or if you need to cut tubes in a different
material.
Two wheels are available depending on the material used for the tube:
wheel for tubes in carbon steel: part no. 162470
wheel for tubes in stainless steel: part no. 162471
●
●
●
–
–
EN
Summary of Contents for 162120
