18
© 2 0 0 6 d i r e c t e d e l e c t r o n i c s
To exit programming mode
The 2-way LED remote control will exit programming mode
after 2-seconds of inactivity and will emit 2 long beeps.
u
ussiin
ng
g yyo
ou
urr ssyysstte
em
m
The buttons described in this manual correspond to the standard
configuration. Remember, this is not the only way your trans-
mitter may be set up. It can be custom configured to meet your
needs. See your installer for additional details.
active arming
You can arm the system by pressing
of your remote for one
second. When the system arms, from the vehicle you will hear a
short siren sound, or chirp, and see the parking lights flash once.
If the power door locks are controlled by the system, the doors
will also lock. While the system is armed, the in-vehicle’s status
LED will flash approximately once per second, indicating that
the system is actively protecting your vehicle. If you hear a
second chirp after arming and note that the in-vehicle’s status
LED is flashing in groups, see the Diagnostics Section of this
guide. This extra chirp is called Bypass Notification.
➜
note:
If programmed Off, no alarms will be notified to the
remote. Command information (Armed/Disarmed) will
be notified to the remote.
