22
© 2 0 0 6 d i r e c t e d e l e c t r o n i c s
After each press of the
to reach the next level of security, the
remote will emit normal arm notification (1 beep and 3 flashes
of the Orange LED). For easiest operation in reaching each level
of security, press
immediately aafftteerr each notification.
disarming
To disarm the system, press
. You will hear two chirps, and
the parking lights will flash twice. If the power locks are
connected to the system, the doors will unlock. If the siren chirps
either four or five times when disarming, refer to the
Diagnostics
section of this guide. This is called Tamper Alert.
The remote will indicate disarm notification with 2 beeps and 3
flashes of the Orange LED. If disarming after the system has
been triggered, the remote control will send a diagnostic notifi-
cation as a reminder. These diagnostic notifications are:
1. If a sensor triggered the system, the remote will beep 4-times
and the Orange and Red LEDs flash 3 times.
2. If a switch (Zone 1, 3, 5, or 6) triggered the system, the
remote will beep 4-times, the Orange LED will flash 6-times
and Red LED will illuminate for 3 seconds.
3. If the system was triggered so many times that NPC is active
the remote will emit the above notifications with 5 beeps
instead of 4.
➜
note:
Multi-Level Security Arming only applies to a sin-
gle arming cycle. Once the system is disarmed and then
re-armed, all the zones will be active again.
