DRAINING THE SOLUTION (CLEAN) TANK
: Anytime scrubbing operation is
completed, the solution tank should be drained
and cleaned.
1.
Pull down on the clear tube (back left of the
machine) to remove it from the hose barb.
This will allow the solution to flow freely into
a bucket or floor drain.
2.
Rinse the solution tank with clean water after
every use. This will help prevent chemical
buildup and clogging of the solution lines.
3.
With clean water in the solution tank, turn
machine power on, solution switch "on" and
pull the operating triggers. This will allow the
clean water to flush through and clean the
solution plumbing.
4.
Once the tank is rinsed, flushed and drained,
reconnect the clear tube to the hose barb. Be
sure the tube is pushed all the way up on the
hose barb.
BATTERY CHARGING
: Use only approved chargers with the
following specifications:
x
Automatic shut-off circuit
x
Deep cycle charging
x
Output current of 20-30 Amps.
x
Output voltage of 36 volts.
: For the best machine performance,
keep batteries charged at all times. Do not let
them sit in a discharged condition discharged
condition.
: Batteries are dangerous! Batteries
emit hydrogen gas and an explosion or fire can
result. Keep sparks and fire away from
batteries at all times. When charging the
machine, make sure the battery compartment
is left open.
1.
Place charger and machine in a well ventilated
area.
2.
Turn machine off.
3.
Open recovery tank up, exposing battery
compartment.
4.
Check fluid level in each battery cell. Do not
charge batteries unless fluid is slightly
covering the battery plates. Do not overfill the
batteries. Overfilling may cause the batteries
to overflow during charging due to expansion.
Replace the caps prior to charging.
5. Plug approved charger into grounded wall
outlet before plugging the charger into the
machine.
6.
Plug charger into grey charger receptacle
located in the front left of the battery
compartment.
7.
Flip up the recovery tank "kick stand" and
gently lay the recovery tank down until it rests
on the stand.
8.
The charger will automatically begin to
charge the batteries, and it will automatically
shut down once the batteries are fully charged.
9.
Upon completion of charging, first unplug the
charger from the wall outlet and then
disconnect the charger from the machine.
10. Check the battery fluid level after charging is
completed. If the fluid level is low, add
distilled water to bring the fluid level up to the
bottom of the sight tubes. Replace the caps
and wipe the batteries down with a towel.
8
