13
© 2000 Directed Electronics, Inc. Vista, CA
transmitter/receiver learn routine
™
The system comes with two transmitters that have been taught to the receiver. The receiver can store up to four
different transmitter codes in memory. Use the following learn routine to add transmitters to the system or to
change button assignments if desired.
When the learn routine has previously been programmed using an optional hand-held system programmer
(
p/n 998T
) or PC Interface module, it may have been locked. Before proceeding with reprogramming the
learn routine, it must be unlocked by using either
p/n 998T
or the PC Interface module - this cannot be done
manually with the Valet switch. If the learn routine is locked, transmitters cannot be programmed to the system.
1.
Open a door.
(The H1/5 GREEN wire or the H1/7 VIOLET wire must be connected.)
2.
Key.
Turn the ignition on. (The YELLOW wire, H1/9 must be connected.)
3.
Select the receiver channel:
Press and release the Valet
®
/Program button the number of
times necessary to access the desired channel.
NOTE:
If adding a remote, a button must be taught to the unit in the Channel 1 or Channel 4 posi-
tion prior to programming other channels, unless programming to one of the Auto Learn
Configurations.
Press and
HOLD
the Valet
®
/Program button once more. The siren will chirp and the LED will blink the number of
times corresponding to the channel that is accessed.
CHANNEL NUMBER
FUNCTION
WIRE COLOR
1
Arm/Disarm/Panic
2
Silent Mode™/Remote Valet
®
/Trunk Release
RED/WHITE
3
Remote Start or other accessories
WHITE/BLUE
4
Arm only
5
Disarm only
6
Panic only
7
Auto Learn Standard Configuration 4-button transmitter*
8
Auto Learn Single Button Arm/Disarm Configuration(optional 471T)*
9
Delete all transmitters
*NOTE:
For Auto Learn Configurations, see Transmitter Configurations section of this guide.