11
www.vip-vision.com
SLR-A45 Series
| Solar Surveillance
3.1 Connect using WiFi
(SLR-A75-4W)
3. Connections
1. Connect a DC jack from the terminal block to the camera.
2. Ensure the Ethernet cable is connected between the camera and the wireless bridge (station).
3. Mount the other side of the wireless bridge (access point) on the building, facing towards the
station on the solar panel.
4. The access point can be powered by one of the following methods:
a. Connect the AP’s network port to a PoE switch.
b. Connect the AP’s network port to the included PoE injector, then connect the injector to a
network switch and a 24V power supply.
5. (Optional) Connect the network switch to an NVR (The camera includes a microSD card for edge
recording).
6. (Optional) Connect the network switch to a router.
Refer to the next page for a WiFi system map example using a PoE injector.
This section covers how to set up the WiFi network for your WiFi Solar Kit. Most of the setup for the
solar panel side of the installation has already been done - it just needs to be connected to the solar
panel battery for power.
Note:
The station side of the wireless bridge (IP address: 192.168.1.21) should already be mounted
under the solar panel.